Commit graph

1 commit

Author SHA1 Message Date
CRT
d159acfd97 Add the post mill
The largest thing in the kit, and the one whose name is its whole design:
the entire body -- millstones, gearing, miller and all -- is balanced on one
massive vertical post and turns bodily on it, so the sails can be pointed
into whatever wind there is. The miller does that by walking the tail
ladder round, which is why the ladder is not a way up but a lever, and why
it reaches so far behind the mill.

Four parts, in the order the thing is built: `trestle` (two cross-trees,
the post standing on them, four quarter-bars), `body` (the boarded buck and
its pitched roof), `sails` (a windshaft leaving the front gable, with its
own origin so `setTurning` spins it alone), and `ladder`. `setTurning`,
`setAngle` and `update` drive the sails at about ten revolutions a minute
-- a working mill turns slowly, not in the blur people draw.

The sails are where the triangles went, and deliberately. A sail is not a
blade, it is a LATTICE the miller dresses with canvas according to the
wind. Drawn solid the silhouette is wrong in the one place everyone looks,
so the bars are modelled and the budget is taken from the buck's boarding,
which reads perfectly well as vertex colour. 1 516 triangles.

Four faults on the way in, all found by measuring rather than by looking:

The roof pitches were built `slope * 2` long and tilted by the complement
of the roof angle, which made two panels 2.79 m across a building 1.80 m
wide, standing up like the covers of an open book. Each pitch covers half a
roof, and the tilt is measured from the horizontal because
`chamferedBoxGeometry` takes an X-Z footprint.

The rails of the tail ladder were tilted the wrong way round. `run` is
positive -- the head sits at a larger z than the foot -- so rotating by
`-lean` laid the rails along the opposite diagonal to the one the rungs
were placed on. They crossed near the middle and diverged towards the ends,
and the bounding box looked correct the whole time because the translation
put the ladder where it belonged and only its internals were wrong. The
support audit found it as loose rungs, and found it only at the small end
of the height slider, where the voxel grid is fine enough not to bridge the
gap: the joint was never real at any size.

Fixing the ladder's foot, which sat 0.10 m below the cross-trees so the
mill hovered above whatever it was placed on, then displaced the rails
perpendicular to their own axis by almost exactly a rung's half-depth --
correcting the rails alone was worse than not correcting at all. Rails and
rungs now share one lift.

And the lowest sail tip came within 0.27 m of the ground, which reads as a
mill about to plough its own field.

28 models, 20 523 triangles, all checks pass, 0 floating cases, GLB
round-trip clean, Conformant at 30 items, build clean.
2026-08-23 13:01:33 +07:00